 As an integral part of the Burke Flooring System, Burke adhesives are formulated to meet municipal, state and federal code compliance regulations. They do not contribute to IAQ (Interior Air Quality) problems when applied as instructed.
A stair tread nose-filler caulking is available, along with the required gun and mixer tips. Another unique feature is that unused caulk can be saved and used later with another clean tip, available from your Burke Flooring distributor!
- Non-flammable formulations
- Adhesives must be used for Burke
Warranty to apply
- Complete instructions on each unit
BR-101
Burke
BR-101 Rubber & Vinyl Acrylic Wall Base Adhesive is a white acrylic latex for cove and carpet base on dry, porous interior walls. It is solvent-free with no VOC (Volatile Organic Compound) emissions.
BR-711
Burke
BR-711 Rubber and Vinyl Stair Tread and Tile Adhesive is specifically formulated for installing rubber tile, rubber and vinyl stair treads, risers, and stair nosings. BR-711 is a solvent-free aqueous adhesive that only needs to be applied to one surface. It allows repositioning of treads during installation. For above grade, porous, moisture-free wood or concrete substrates. Solvent-Free with no VOC emissions.
BR-710
Burke BR-710 is a One-Part Urethane Adhesive for use with EcoScore and EcoFitness Flooring. It is available in two and five gallon containers and does not need to be mixed with an activator.
BR-715
Burke
BR-715 Solvent-Free Epoxy Nose Filler prevents cracking or flexing of treads and nosings by uniformly molding a strong bonding support to the under step. When properly mixed it will not sag and will repair cracks, holes, depressions, worn and broken stair edges. This solvent-free epoxy may be used on wood, concrete, or non-galvanized metal stairs. NOTE: All Burke Stair Treads must use nose-filler in the nose, if any void exists between nose and substrate.
BR-721
Burke
BR-721 Solvent-Free, Two-Part Epoxy Tile and Stair Tread Adhesive is used for 12 x 12 rubber tiles, Rouleau Tile, Rubber and Vinyl Stair Treads and nosings. BR-721 is for use over porous or non-porous substrates.
BR-725
Burke BR-725 is a Solvent Free, Two-Part Urethane adhesive that is formulated to tolerate black cut-back or asphalt adhesive residue. When removing old tile or floor coverings, black cut-back or asphalt adhesive should be scraped up and disposed of according to local regulations. However, some residue may be left in the pores of the concrete or wood substrate. BR-725 can tolerate this residue. It also can be used anywhere the BR-721 can be used.
 Step-Bond Adhesive Tape
Burke Step-Bond is a super strong, double sided, self-adhesive tape developed for the installation of stair treads, risers and stringers. Step-Bond is available in either one-inch or six-inch wide rolls.
Step-Bond Tape is also suggested as an alternative adhesive for Burke’s Rouleau Uni-Step Tread/Riser.
Step-Bond is a labor saving alternative to traditional canned glue with no applicators or messy clean-up. Simply roll tape onto tread or riser surface, peel off the protective paper backing and stick in place.
|
